Citroen C4 Cactus Crossover Forum banner
1 - 7 of 7 Posts

Registered
Joined
13 Posts
Discussion Starter · #1 ·
Hello,

Hopefully someone can help me, had abit of a nightmare this morning in a rush reversed out and hit my fence :lol: , small scuff which probably can be polished out but part of the plastic trim under the rear light has popped out and can't seem to put it back in any help would be much appreciated

Thanks
 

Registered
Joined
735 Posts
Can you supply a photo of the car not the fence ;)
 

Registered
Joined
735 Posts
Definitely looks like it should pop back in. But apart from googling, I don't know how to go about it :(
 

Registered
Joined
735 Posts
A before photo :D
Hope it helps?
 

Attachments

Registered
Joined
626 Posts
Not directly relevant but this vid demonstrates how to fit the side panels. Can't imagine the method is going to be much different?


Perhaps realigning the panel, piece of thin plywood/ thick scrap card and a gently tap with a hammer or non maring mallet.

That said...

I can't work out if image 21 is front or rear bumps which ever it looks like it's on clips...

http://www.motorionline.com/foto/citroen-c4-cactus-airbump/21/
 

Registered
Joined
735 Posts
It's just occurred to me that Citro毛n advocates changing bumps to a different colour, therefore they would have to be removed and replaced! Perhaps you will have to pull off the bump and check the fixings before being able to put it back correctly ?
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top